- #Cube pro motor com failure install
- #Cube pro motor com failure full
- #Cube pro motor com failure software
- #Cube pro motor com failure code
In fact, we do not recommend updates in general there is no obligation to perform updates.
#Cube pro motor com failure install
You should always drive a few kilometres with the new Bosch Gen4 engines before you install a tuning module.Consequently, simply do not drive faster than 35 km/h permanently with engine support! Therefore, we do not recommend optimizing above 35 km/h permanently. Of course you can usually set higher values with the tuning tools, too - but you do this at your own risk.
#Cube pro motor com failure software
With higher values it is possible that the anti-tuning software will recognize the tuning. However, some tuning manufacturers advise to set the maximum engine support to a maximum of 33-35 km/h ( RedPed 2 and SpeedChip V3).
#Cube pro motor com failure full
As a rider, you can restore full functionality by riding for 90 minutes in the downgraded mode.
#Cube pro motor com failure code
If this is the case, a restricted mode is activated - this means that error code 504 appears in the display and the motor support is strongly reduced. This software is designed to use sensors to detect whether the E Bike has been tuned. The special feature of these drive systems is that they are equipped with a special anti-tuning software. Here you can find tuning tools which are compatible with the new Bosch 2020 E Bike drive systems - corresponding engines are often called "Bosch Gen4". Bosch 2020 Tuning Bosch 2020 tuning products at a glance